Lorex Technology L19lD1616501 Instrukcja Użytkownika Pobierz pdf (Strona 52)

Hard Drive Replacement - Appendix #7

STEP 1: Remove the Drive Cartridge from

the System:

• Lift the lever to gain access to the Lock

Mechanism. Use the provided key to

unlock the drive bay.

• Pull upwards on the lever to loosen the

Drive Cartridge. Pull the drive cartridge

out of the System to access the SATA

Hard Drive.

STEP 2: Remove the Cover from the

Cartridge:

• Un-clip the release latch with the word

“OPEN” printed beside it by gently

pushing on the latch.

• Slide the cover off to where it locks or

catches the stopper and lift the

Cartridge Casing to remove it.

STEP 3: Connecting the SATA Cables:

• Confirm the SATA Cable is securely

connected within the System.

• Connect the SATA Data Cable to the

Drive (Cable with two black, one red and

one yellow wire).

• Connect the SATA Power Cable to the

Drive (single red cable).

Hard Drive Replacement - Appendix #7

The System comes with a pre-installed Hard Drive (located in the removable drive bay). This

system will work with two (2) installed hard drives (at a max 750GB each). The steps below

outline installing a drive in the removable bay - if installing an internal drive, it is recommended to

speak with a PC Hardware Technician for assistance.

NOTE: Make sure that the System is OFF and the power cable has been disconnected before

changing the Hard Drive.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 58

Brak uwag

Lorex Technology L19lD1616501 Instrukcja Użytkownika Strona 52